10-07-2011 09:34 AM - edited 03-17-2019 10:32 PM
Team,
I have two EX90's, not VCS yet. Custoemr want to set them up to call each other. Is this possible, if sow what configurations are required?
thx,
Robert
10-07-2011 12:26 PM
In theory, two Endpoints running TC4.x can call each other withou registrations. You need to enable H.323 and SIP and not point to any server. You will need to dial using IP address.
10-07-2011 02:14 PM
Hi Robert,
The most important is to set the H323 CallSetup mode to Direct. This will allow you to make H323 calls by dialling an IP address.
10-08-2011 12:30 AM
Other option using cisco call manager to register those both endpoints without the need to use vcs
Hope this help
If helpful rate
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
