02-17-2017 11:42 AM - edited 03-18-2019 06:54 AM
Hello everyone,
I am setting up an Expressway-E, after loading the Advanced Networking option key and restarting the device, it is still only showing LAN1 in both IP configuration and in the ethernet settings.
Any ideas?
Solved! Go to Solution.
02-17-2017 12:27 PM
From a VCS Admin Guide:
To enable the use of dual network interfaces:
1. Ensure that the Advanced Networking option key is installed on the VCS Expressway.
2. Set Use dual network interfaces to Yes.
3. Set External LAN interface to LAN2.
You should configure the LAN 1 port and restart the VCS before configuring the LAN 2 port.
■
The LAN 1 and LAN 2 interfaces must be on different, non-overlapping subnets.
02-17-2017 12:27 PM
From a VCS Admin Guide:
To enable the use of dual network interfaces:
1. Ensure that the Advanced Networking option key is installed on the VCS Expressway.
2. Set Use dual network interfaces to Yes.
3. Set External LAN interface to LAN2.
You should configure the LAN 1 port and restart the VCS before configuring the LAN 2 port.
■
The LAN 1 and LAN 2 interfaces must be on different, non-overlapping subnets.
02-17-2017 12:40 PM
Ah yes, setting the use dual network interfaces to YES would probably help!
Thank you.
04-10-2018 07:31 AM
"Use dual network interfaces" should be on Ethernet Menu, not on IP menu, btw.
System-> Network Interface -> Ethernet
not System-> Network Interface -> IP
Or just a single menu for all.
Some of us are still very OSI oriented.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide