Have some tunnel-groups configured, tunnel-group-list enabled under webvpn, but I need users to have always a particular one as default every time they connect, and all the other ones as options in Anyconnect client version 3.1.x, ASA 9.5. I don't wa...
I need to build the case for Cisco for a virtual WLC in HA scenario. I know about SSO in hardware appliances. Does a couple of vWLC in co-located ESX boxes works in HA. Documentation is too old and I don't understand why the limitation stood for so ...
One of my integrated BRI slots is broken but lucky as I am I have a free T1/E1 PRI interface unused and unplugged!It's a UC500.The BRI was using the two possible channels.How can I configure the PRI slot to communicate with the provider's NT1I know i...
Hello there.One of my clients wants to call to his company UC520 from his cell and make calls from there to save rates, etc. I cannot find a config, implementation guide, to start with. I don't know what to search for.Thanks
I said "probably" because I have seen this many time. In my many years of experience I have seen that casual administrators don't keep track of DIDs, unless a translation is created in IOS or CUCM incoming, and not even then, because they ignore what...
You probably are looking for the External Phone Number Mask, which is in the Line Appearance of the Device/Phone you are searching after.It is a common misconception from Cisco not to try to understand the system for the casual administrator. The onl...
Here's another ccie collab annoyed by this. I remember I have tried this several times... no luck. I never seen this working.This last time on Everest: 16.6.4
Before rebooting the whole Manager. Try to goscope httpand set http server to disable, then after some time, re-enable it. This is less stressful than CICM full restart, because you know you have SSH.I have recoveres some machines with only this. And...
