H.323 Gateway Issue?

[mingl]

Hi:

I'm a new coming in the forum. Recently I have met some problems in the situation below:

A CUCM6.0 Server Add a Gateway RouterA,

Another CUCM6.0 Server Add another Gateway RouterB, RouterA & RouterB interconnected through any networks and Using H.323 Voip Dial-peer.

I have a question here:

Is this a Valid configuration? If it is, for the perspective a routerA, It have two call legs both Voip dial-peer, is it valid? I have tested this scenario, it doesn't work on my network, Is something wrong with me, or I need some special config command.

Thanks for any advices;

Robert Li

[Jaime Valencia · Accepted solution]

if you attempt to join two voip dial peers you need a CUBE

HTH

java

if this helps, please rate

[connect101]

Is it possible with CCME and Video Advantage?

[Jaime Valencia]

no, CUBE is separate from CCME and VTA

HTH

java

if this helps, please rate

[m.murad]

Are you trying to send a call from your CUCM which is connect to a H.323 gateway on to another Voice Gateway? IF this is what you are trying to then yes this is possible using VOIP dial-peers. Post your config and I'll see if I can help.

Basically though I have a senario where my calls to my gateway and then I have a dial-peer which sends the call to another gateway that is accessible by my gateway and then that call is forward to the remote gateway phone or out the PSTN.

[huydien3384]

I did it successfully, but some problems occur, plz help

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=Video%20over%20IP&topicID=.ee6c82f&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc2992b