02-03-2022 06:59 AM
I was given one of the newer 21" Webex Desk units. I have it registered to my on Prem 12.5 Call manager and it works great.
What I can t figure out is how to either remote into it via SSH or Web like I used to on my SX/DX units. I did my best googling on the issue, and did manage to remote into it after a system reset before it's configured for Call Manager. but once registered to CUCM I can no longer access it. I think if its Webex registered it's remote-able, but thats not my use case here. I wan to run it on prem.
Running RoomOS 10.9.1
Any suggestions?
Solved! Go to Solution.
02-03-2022 06:17 PM
HTTP (web interface) and SSH (used for command line) can be enabled/disabled in the endpoint configuration on CUCM. This is likely what is preventing your access to the endpoint's web interface and command line interface.
Please remember to mark helpful responses and to set your question as answered if appropriate.
02-03-2022 06:17 PM
HTTP (web interface) and SSH (used for command line) can be enabled/disabled in the endpoint configuration on CUCM. This is likely what is preventing your access to the endpoint's web interface and command line interface.
Please remember to mark helpful responses and to set your question as answered if appropriate.
02-07-2022 02:11 PM
Thanks Wayne. You were 100% correct. I didn't enable Web and SSL in the CUCM Config. I had thought I did, but ... 🤷🏼
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide