cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
246
Views
0
Helpful
1
Replies

How to bypass Permissions Wizard on Unity 5.0 install

arielroza
Beginner
Beginner

Hi, guys.

I have a customer that does not allow me to run the Permissions Wizard to set up Unity 5.0 into their AD infrastructure. They want to set up the permissions manually.

I am ok with that, but the Unity setup REQUIRES me to run the PW to set the security.

How can I bypass the check for the PW on the CUICA, to proceed with the rest of the setup?

If there are problems with permissions, I´ll handle them later, after the base software is installed.

Warm regards,

Ariel

1 Reply 1

Scott Hills
Cisco Employee
Cisco Employee

Hello,

I  believe that you can run permission wizard from command line and add in a switch:

   permissionwizard.exe /localonly


To my knowledge this will bypass setting permissions in the AD.


However the TAC supported method is to run without any switches.


Thanks,

Scott
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers