08-23-2012 01:34 AM - edited 03-19-2019 05:25 AM
Hi guys,
I'd like to know how to hide the number of the caller on cucm 8.5
Solved! Go to Solution.
08-23-2012 06:22 AM
OK, if you want to change this for all calls simply adjust "" to RESTRICTED on
all Route Patterns pointing to PSTN. If you want to do this only for some users you will need to copy all the route patterns and assign them different partition reachable from that phone.
If you want it to work on demend, i.e users dial *67 followed by the number to block caller ID, copy the existing route patterns and add *67 to the front and set this "" to RESTRICTED.
HTH, please rate all useful posts!
Chris
08-23-2012 06:09 AM
Are you asking to hind caller ID on outbound calls to PSTN, inbound calls from PSTN, calls between IP phones?
Chris
08-23-2012 06:17 AM
08-23-2012 06:22 AM
OK, if you want to change this for all calls simply adjust "" to RESTRICTED on
all Route Patterns pointing to PSTN. If you want to do this only for some users you will need to copy all the route patterns and assign them different partition reachable from that phone.
If you want it to work on demend, i.e users dial *67 followed by the number to block caller ID, copy the existing route patterns and add *67 to the front and set this "" to RESTRICTED.
HTH, please rate all useful posts!
Chris
08-23-2012 07:42 AM
awesome, work perfectly !
regards
04-20-2016 08:32 AM
It's not working on my CUCM 8.6
My call setup below.
phone-cucm-sip trunk- ISP-(SBC-Genband) - cell phone
I created spereate rp and call is matchint correct rp fine i alwo selected under rp "Calling Line ID Presentation" to RESTRICTED but still seem caller id on cell phone.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide