cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
868
Views
0
Helpful
2
Replies

stuck with nm-cue-ec and a 2851

Hi,

I read so much stuf in the last weeks and still have no idea how to get the nm-cue-ec running on a Cisco 2851 router.

I can access the web interface of Unity Express and this ask for a username password to initialize the system. All commands I found to configure a username for that faild because the commands are unknown.

IOS is ipvoice 12.4-24 T6 and it seems that the CUE is running version 3.0

Callmanager is Version 7.1.3

Is there a different IOS needed?

interface Service-Engine1/0

ip unnumbered GigabitEthernet0/0

service-module ip address 10.10.10.21 255.255.255.0

service-module ip default-gateway 10.10.10.22

!

ip route 10.10.10.21 255.255.255.255 Service-Engine1/0

Anyone has an idea how to upgrade CUE or get into it?

any help is welcome...

Eike

1 Accepted Solution

Accepted Solutions

barry
Rising star
Rising star

Hi Eike

Have you tried using the "service-engine" exec command on the 2851? You should be able to use this to run a local session onto the service module itself. From there, you should be able to define a new admin account, or even completely wipe and reimage the CUE module.

"service se1/0 session"

HTH. BArry

View solution in original post

2 Replies 2

barry
Rising star
Rising star

Hi Eike

Have you tried using the "service-engine" exec command on the 2851? You should be able to use this to run a local session onto the service module itself. From there, you should be able to define a new admin account, or even completely wipe and reimage the CUE module.

"service se1/0 session"

HTH. BArry

wow fast answer and perfect answer.. I didn't try that.

Now I'm in and will start over.

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers