05-01-2019 09:12 AM - edited 05-01-2019 10:44 AM
The old switches had fastethernet interfaces and the new switches have gigabit interface. The new switches are using the same IPs as the switches they replaced. CER still shows the old fastethernet interfaces.
Is there a particular method of refreshing the switches so they show the proper interface names?
05-02-2019 01:23 AM
Phone Tracking > Run Switch-Port & Phone Update
05-02-2019 05:40 AM
Thanks, I have 33 switches and wasn’t sure how long it would take to refresh so I didn’t know if I could do it on the fly. With 33 switches is this something I should do during a maintenance window? Also, is there a way to update the switches one at a time? There’s not much detail on the actual process on the website or help pages.
05-02-2019 06:34 AM
05-03-2019 07:55 AM - edited 05-03-2019 07:56 AM
Thank you very much I will give it a try and update the thread.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide