upgrading CUCM from 9.1 to 11.0

[kingsleyb]

I am planning to perform an upgrade of our production CUCM. I requested the upgrade software from cisco and they sent me an e-download. I only realized after the request that i need to perform the upgrade using the 'restricted' version. I am fairly sure that i requested the restricted version but is there a way for me to tell by looking at the iso file name or description whether it is restricted or not? thanks in advance.

[Rob Huffman · Accepted solution]

Hi there,

The "Restricted" or common version file would look like this;

UCSInstall_UCOS_11.0.1.20000-2.sgn.iso

The "Unrestricted" or less used version file would look like this (note the UNRST);

UCSInstall_UCOS_UNRST_11.0.1.20000-2.sgn.iso

Cheers!

Rob

[Aman Soi]

[+5 ] to Rob.

In e-delivery if u get Part Code starting with "R" , that means it is restricted version.Can u check ?

regds,

aman

[kingsleyb]

hi Aman, looking at the e-delivery email now and dont see an R. did check my software download iso as mentioned by rob and it looks like it is UCSInstall_UCOS_11.0.1.20000-2.sgn.iso

thanks for your help!

[Aman Soi]

Hi,

Can u share the snapshot of OBA from E-delivery having products ordered?

regds,

aman

[kingsleyb]

[Aman Soi · Accepted solution]

Thanks for sharing.I checked further "R" is for electonic delivery.

UCM-11.0-SW-K9 is for Restricted S/W while UCM-11.0-SW-K9-XU is Unrestricted.

So, what u have ordered is RST version.

regds,

aman

[kingsleyb]

thanks for the information Rob, much appreciated. 

[Rob Huffman]

Hi Aman,

Thanks for the good additional info here my friend (+5!) Hope all is well with you.

Cheers!

Rob