Blade failure recovery

[delahais]

Hi,

I have associate a SP to a blade.

If the physcial blade failed, could I configurate the SP in order that automatically the SP should be  associated with another free blade ?

If YES, how I have to configurate the SP or SP template ?

Thx for your feedback

Best regards

Nicolas.

[Keny Perez · Accepted solution]

Hi Nicolas,

I would give you a big answer to complicate the escenario, but Robert Burns answered this same question (unles I misunderstood you) a few days back, see this:

https://supportforums.cisco.com/message/4032942#4032942

The logic he explains is the reason why this is not done in UCSM.

I hope this helps with your question.

-Kenny

[delahais]

Thx Keny for the url.

-Nicolas

[Keny Perez]

Sure Nicolas, my pleasure.

-Kenny