MMNEXUS01# sh int status--------------------------------------------------------------------------------Port Name Status Vlan Duplex Speed Type-------------------------------------------------------------------------...
I am having some fan issues on the C200. The fan is revving up randomly even with no load.According to TAC the reason the fans are revving up randomly is because the firmware we have installed on the C200 M2 server does not support ESXi 5.1. TAC sa...
Hi AllI have some clarification regarding the connectivity like which cables are used to connect them and how as below. Please help me to clear themAs of i understood we use for short distance Twinax and longer distance Copper cable.Fabric Inter conn...
hi: I login to cisco cimc via browser and try to create some local users. later I want to delete these users and can not find how. the document only mention how to add user and modify their rules / passwords, but it didn't tell how to remove old u...
All,We are experiencing an issue with some virtual Kemp LB's in our environment where they are not functioning properly with regard to multicast, and their HA.We came across a doc that seems to point to a possible solution:https://supportforums.cisco...
Hello,Is there any DETAIL OID list availble for all UCS Related MIBS? I have found some document but none of them have FULL listing of all OID available for UCS? What are OIDs availble for Network and FCOE uplink port perfornmance monito...
I recently migrated our ESXi hosts from HP servers to UCS B230 blades. As part of this configuration I set up the fabric interconnects so they are in FC Switch mode since I plugged in the fiber from the fabric interconnects directly into the VNX stor...
C460-M2 with 2 VIC-1225; all documents show only one VIC-1225 (which has to be in PCI slot nr.1) single wire managment with a UCS FI ?Is this a limitation ? or must the second VIC-1225 be connected to a switch outside the FI ?Walter.
Hi all,We went through a firmware upgrade on our UCS environment from 2.1.1e to 2.1.2c on Thursday. The updates appeared to go well, but almost immediately, we've been seeing storage performance issues on 5 of our 9 blades (ESXi 5.1U1 servers). The...
Hello folks, In order to upgrade to UCS Central 1.1 there is a requirement to increase the disk1 size to 40 GB from 20 GB as was needed before. Now when I try to use Gparted it doesnt recognize the partition (lists as unknown format )and therefore d...
I have a pair of 6120XP fabric interconnects and am licensed for 10 ports. The majority of these ports are 1GbI am moving to 10Gb and going to plug in two more connections. That would mean I am using 12 ports, but once the 10Gb are connected I plan...
Hi All,Does anyone know of an instant where C240 M3 servers are not discovered, in a UCS 2248/N2K (2232PP) environment. FI is running 2.1(a) and the C servers' firmware is 1.5. We are trying to connent through the single-wire management configuration...
Hi,We seem to be having issues with not being able to vMotion between ESX hosts on UCS platform. Currently HA is not working. Here's a background of the setup:We have a UCS Platform installed (6508 chassis, B200 M3 blades and 2 x 6248 FIs. This co...
I have 2 fabric interconnects, A and B. I need to change the ip address of A so I failover the cluster to B. how do I change the ip of A via the command line. and will I be able to connect back to it after changing the ip?
