cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
639
Views
0
Helpful
2
Replies

CIMC GUI not responding after update

shopa
Beginner
Beginner

I have apic on UCS C220 M5 Rack Servers. I update CIMC and other components using HUU to version 4.2.2a. After update CIMC GUI is not responding. I can ssh to CIMC ip address and the apic is seen in aci fabric as Fully fit. I have rebooted cimc, disabled and enabled http service from ssh sesion but it didn't help. Any ideas why CIMC gui would not work? Any help would be appreciated. Thank you!

2 Replies 2

will this thread helps?

https://community.cisco.com/t5/unified-communications-infrastructure/cimc-gui-not-working/td-p/4295379

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

No. CIMC GUI worked before update. This is my cimc/network configuration.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: