Nic Teaming and Port channel

[opnineopnine]

Hello 

I have to configure the port channel for the nic teaming I have created in the ucs 240 , this is the actual config I have but is not working

Any ideas? 

thanks.

interface Port-channel2

description UCS01

switchport mode access

ip dhcp snooping trust

interface GigabitEthernet1/0/3

description UCS-01

switchport mode access

spanning-tree portfast

channel-protocol lacp

channel-group 2 mode active

interface GigabitEthernet2/0/3

description UCS-01

switchport mode access

spanning-tree portfast

channel-protocol lacp

channel-group 2 mode active

[Keny Perez · Accepted solution]

Just asking... do you really need the port-channel to be in "access" mode?  Usually the ports are configured for edge trunk so you can take advantage of virtualization and the port can come up faster while passing multiple vlans.

Did you set up a native vlan in the UCS side?  are the ports on the UCS part of the same PCIe card?

-Kenny

[opnineopnine]

Hello Keny

I will to do the change to edge trunk and for the ucs side, I have configured all vlans not a specific one.

thanks.