cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7128
Views
0
Helpful
4
Replies

UCS 5108 error log

rramlal
Level 1
Level 1

Hi Guys,

I got this message on my chassis, can you advise what this means and how can it be cleared:

  •     sys/chassis-1/blade-2/mgmt./log-SEL-0 capacity is very low.
4 Replies 4

Wes Austin
Cisco Employee
Cisco Employee

You can review the SEL (system event logs) by highlighting the server in question in the equipment tab, selecting "SEL Logs" tab on the right hand side and check what is logged.

You can also clear the logs or export them using the same window.

HTH,

Wes

Hi, Thanks for the prompt response.

The description is: log capacity on management controller on server 1/2 is very low. What can I do to resolve this?

Hello,

Please clear out the SEL log. This will resolve the errors, and clear the faults. If you see messages re-occur immediately for hardware, etc, then address them accordingly.

Please select this answer as the correct one if it helps to resolve your issue.

HTH,

Wes

The proper way to do it, is creating a "SEL Policy" under "Global Policies", which logs the content of the SEL buffer to e.g. a FTP server, and then clearing it. If you don't do anything, the SEL buffer fills up, and all the events after are lost, which might become a problem in troubleshooting the blade hardware.

Review Cisco Networking for a $25 gift card

Review Cisco Networking for a $25 gift card