About abdel_n

abdel_n · 12-01-2014

I need to retrieve SLB MIB variables from a router agent: The snmpwalk snmpwalk -u v3user -A v3authpass -a SHA -l authPriv -X v3authpass 192.168.5.202 -v3 works $ snmpwalk -u v3user -A v3authpass -a SHA -l authPriv -X v3authpass 192.168.5.202 -v...

abdel_n · 10-26-2014

Hi,I am thinking about purshasing a refurbished physical server for VIRL, but I have a couple of questions.Here are the requirements provided on http://virl-dev-innovate.cisco.com/ :Four CPU cores and 8GB of DRAM, more resources allows for larger sim...

abdel_n · 07-25-2007

Hello everyone,To practice QoS I build a trivial topology (attached image) to simulate a link bottleneck: - A WAN connection 1.544 mbps between two LAN, both r1 and r2 are performing static NAT for the internal PC1 ,r1(inside local=172.16.1.1, inside...

abdel_n · 12-01-2006

Hi,In a lab environment I have configured multicasting of one video source (using rtp) to a receiver host.All routers are configured for sparse mode with one static rendezvous point.The command mstat at the receiving router shows 95 to 99 percent of ...

abdel_n · 09-26-2006

Hi,I have a problem with DHCP relay agent on pix configured for simple PAT (Lab envirement)All works fine with client ip statically configured:***DHCPRelay(config)# sh conn1 in use, 4 most usedTCP out 193.168.10.201:23 in 172.17.10.2:2022 idle 0:00:0...

abdel_n · 12-03-2014

Thanks Vinod for your reply. I switched to snmpv2, looks like help the GUI browser to get some scalab objects, but still cannot retrieve any table through snmptables (0 row) From CLI snmp: Can get any scalar variablestables and their tabular object...

abdel_n · 11-01-2014

Thanks Geevarghese for the information,Though I have been answered, I must say I am very disappointed by Cisco response.The corporate CML looks very interesting, but not VIRL at least the way it is presented to the community. I was expecting somethin...

abdel_n · 04-22-2014

Hi,As stated by Julio, check R4 neighbor table and make sure the default route in the routing table is pointing to existing R2 link-local (fe80::).

abdel_n · 04-16-2014

Thanks mtimm, nice doc.

abdel_n · 12-29-2012

Hi Chris,According to Cisco Doc the command defines a pool of IPv6 prefixes (network portion /48) to be assigned to users (/64)So users will get 64-bit network portion addresses in the following form:2001:db8:0055:XXXX/64Important note:IOS version pr...

Member Since	‎02-01-2004 08:49 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	137
Total Helpful Votes Received	55

User Statistics

User Activity

Cannot access any of SLB OIDs on the router agent.

VIRL physical machine requirements and performances

VoIP QoS - breaking voice and flapping interface ?!

Multicasting > 95% of traffiic loss !!!!!!!!

Problems with DHCP relay on PIX

p { margin-bottom: 0.1in;

Re: VIRL physical machine requirements and performances

Hi,As stated by Julio, check

Thanks mtimm, nice doc.

Re: DHCPv6 stateful configuration