About aalbrecht27

aalbrecht27 · 11-03-2014

We're running CPAM version 1.5.0(0.3.17). The time is off by about 2 hours, even though it is config...

aalbrecht27 · 10-22-2014

I need to find out how to allow our IVR system to make outbound calls. Currently our IVR can receive...

aalbrecht27 · 10-22-2014

I found the duplicate IP address, it was on another switch as another L3 vlan but it wasn't even up....

aalbrecht27 · 10-03-2014

If there was a duplicate IP then why weren't these log messages present before I made the config cha...

aalbrecht27 · 10-02-2014

That's what I'm a bit confused on, the configs from the L3 vlan interfaces were simply moved to the ...

aalbrecht27 · 10-02-2014

I recently changed some configs on two L3 switches running OSPF. After this change I'm now getting t...

aalbrecht27 · 06-06-2014

Thanks all for the great suggestions! I think I'll go this route and just have them log in and out o...

aalbrecht27 · 06-06-2014

I don't think the hunt group logout softkey will work, simply because some of the administration use...

aalbrecht27 · 06-05-2014

I have a hunt group currently setup to ring on all of our administration phones, and if no one answe...

aalbrecht27 · 07-23-2013

Just tried again with the below script, and it still won't work, even if I just invoke it for a sing...

aalbrecht27 · 07-23-2013

Here is an output of a session I just did. Both ports are currently up, but the script doesn't shut ...

aalbrecht27 · 07-23-2013

Looks like I got a bit ahead of myself because I can only go one port at a time. Is the range comman...

aalbrecht27 · 07-22-2013

ahh I figured out the problem. I needed to add a $ symbol before argv 0 I just updated the tcl file ...

aalbrecht27 · 07-22-2013

I'm having some trouble getting this to work so let me just give a quick rundown of what I'm doing t...

aalbrecht27 · 07-22-2013

Thanks so much, I'm not very well versed in TCL scripting but I see how that would work. Just as an ...

CPAM NTP Time Not Updating