Its been 2 days i have been observing that pages keep loading even though page loaded, Looks like its still try to get some content on the background - i tried different browsers same issue (is this me also every one at community ?)
see the circle ( ...
what is the version of code running - You can try either below method that should work for you :
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/ts/guide/trouble.html
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/3-1-1/s...
check the below thread to find out more about what caused the issue :
https://community.cisco.com/t5/cisco-bug-discussions/punt-inject-5-drop-punt-cause-punt-cause-policer-drop-packet/td-p/3959555
Hello support
i am not sure iam the one who facing the issue, but i checked same time on mobile i see the same time
i am based at +0:00 BST - around 8 am to 9 am between the community site losing the connection in the middle of my comments, and a...
Stack make 2 Physical device in to one Virtual Switch, so one Switch act as Master and other one will be Stanby or member to become active when master switch fails, (there are some requirement to make this work - high level you need to have same mode...
First you need to tell us what is the current version running and make sure upgrade path is correct.
check install steps :
https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r7-7/system-setup/configuration/guide/b-system-setup-cg-as...
As suggested check the config register first.
also i would like to see dir bootflash: or dir flash: all the files.
Also check the content of packages.conf
more bootflash:packages.conf - this should be pointing to new IOS XE packages.
have you looked...
Depends on the design and end device have dual home connection you can achieve with minimal Service impact, (depends Layer 2 or Layer 3 moving here)
Connect Nexus 5K and 9K Layer 2 extension Move the Physical connection to Nexus 9K one service at a t...
VRF means different instance, so you need to make configuration and poll per VRF based.
what nexus code running here,. worth check the configuration guide :
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/105x/config-guides/cis...