Attempting to set up a C1111-4PLTEEA router to use a 4G sim for the first time in the UK.
We have a multi-sim from EE, which can connect to multiple providers.
The output below implies it is trying to connect to the 3 UK network, with no service
Can ...
I get this error, when trying to join an AP model C9124AXI-ROW to EWC on C9120AXI.
According to the compliance tool the model is supported.
The EWC/WLC is running version 17.3.8a
Wireless LAN Compliance Lookup (cisco.com)
We have a customer that wants to run telemetry & NetFlow at the same time on ACI running Version 4.2(7l).
I believe this was not supported on earlier versions of ACI, but want to know if it is supported on Version 4.2(7l).
I need to change the selected Smart Account User within Settings / Cisco Accounts / Smart Account. If i try to add a new username, i get the option to add a username & password, but the Save option is greyed out on the bottom right-hand corner. If i...
I have 2 x 9120axi EWC APs & i cannot get the day 0 configuration to work.
They are both running version 16.12.04a & i go through the setup procedure where prompted to input the ip address for the interface, subnet mask, default route & username/ pas...
Thanks for the reply, will try that. Do you know if it is possible to have both 9120 & 9124 APs on the same network, without a 9800 WLC.
How would we download the image to a 9124 from a 9120, or vice-versa?
I have resolved this issue, you need to use dhcp when you boot AP out of the box.
then complete the tasks following he command "cat ewc_day0_device_provisioning_guide"
then run setup to manually configure the mgmt ip address & overide the dhcp assig...
I have also ran the command "cat ewc_day0_device_provisioning_guide" & followed all of the instructions listed in the displayed text output. Still no SSID being broadcast & i still cannot ping the interface. I have tried configuring the switchport as...
The WAP is running version 16.12.04a & i have followed the steps in both the document & that video, but i still do not see the SSID being advertised.
I have also followed the steps in the guide included in the bootflash "ewc_day0_device_provisioning_...
