About vmiller

vmiller · 04-30-2015

show cdp neighbor fastethernet1 Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone, D - Remote, C - CVTA, M - Two-port Ma...

vmiller · 01-14-2015

I'm trying to come up with a means to capture trunk status changes in NX-OS using logging event trunk-status.I'm puzzled by the fact that at the port channel configuration level, if I configure logging event trunk-status enable, itstays as default.at...

vmiller · 04-07-2009

We have just installed 4 NAMS in 2 pair of switches. (65xx, CATos 7.6.7) only 1 of the 4 can see its parent swtich. The one NAM that can communicate with its parent has a line in the nam config:netflow device 127.0.0.11 m***** (correct snmp communi...

vmiller · 09-05-2008

Does anyone no a means by which one can determine how much traffic is hitting a policy map or a traffic shaping definition?

vmiller · 02-29-2008

If anyone has any experience (good,bad, indifferent) with running BCP over Sonetand using APS I would be very intersted in how it performed. Thanks

vmiller · 12-14-2017

https://www.cisco.com/c/en/us/products/collateral/routers/7200-series-routers/data_sheet_c78_339749.html The device is a little outdated, but in its time it was a workhorse in many networks.

vmiller · 08-03-2017

You might get it to work, but given the caveats above (straight from the 4331 doc) why risk it? I doubt if the TAC would be much help if you did.

vmiller · 08-03-2017

short answer, no Gigabit Ethernet Management Interface Overview The router provides an Ethernet management port named GigabitEthernet0. The Ethernet management port allows you to perform management tasks on the router. It is an interface that should...

vmiller · 10-19-2016

Since your account is just "guest" you probably won't get much in the way of pricing online. If your employer is a Cisco customer, you might be able to leverage that. If you work with a reseller, and they have a relationship with Cisco, that is the ...

vmiller · 10-18-2016

I get the situation. I do not know of a way to validate TX/RX without bringing a port up active. Did you try the Optical networking forum ?

Member Since	‎03-13-2002 03:36 PM
Date Last Visited	‎12-21-2017 03:50 PM
Posts	1,294
Total Helpful Votes Received	326

User Statistics

User Activity

Suppress output in show CDp neighbors

Logging event link status and trunk status

NAM installation issue/question

Measuring the affect of policy maps

Bridging Control Protocol SONET

Re: cisco 7200 VXR router

You might get it to work, but

short answer, no

Since your account is just

I get the situation.