Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When Installing the Cisco Unified TAPI for a third party software, we can't find any audio device to connect to. We use a Win7 plattform We used the the following dev guide: http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/tapi_dev/10_5_2/CUCM...
Dear all,
I was updating several different Telepresence Systems from TC7.3.4 to TC7.3.6 and was facing an issue with the TelePresence Profile 52 Dual (C60) Systems (3 Systems).
I installed the files on the "Profiles" and could see that the Version T...
Hi, When configuring and saving something on CUCM 10.5 with multiple browser tabs open, I receive the following error:-------The attempted action was a violation of security protocols and will not be allowed. This may be caused by having multiple con...
Hi all,I have some few users that have a problem with the webex reminder from cisco Jabber (9.2.2) - 10 minutes before the meeting, there comes a popup which shows "meeting will start in 246095968 minutes"I have no clue where i could start troublesho...
Hi Pradeep,Thanks for your feedback. But even when we use the Media driver, we can't a find an audiodevice in Windows (7).Do you have any clue what could be the problem?Best RegardsDaniel
I know that this Topic is very old, but I was facing the same issue. The solution is:Connect via CLI (SSH) to WLC and type "debug fastpath cfgtool --dump.sfp"you dont need to type "FP0.", thats part of the output I censored the output with XXXXXX:(Ci...
Thats exactly the point, we found out that the incoming dial-peer didnt work properly.We have configured a new one with "incoming called-number" instead of a "destination-pattern"(+DID) and it seem to work fine. Thanks for the explanation and confirm...
