Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was having an issue with the Code upgrade on ASR9901 from 7.6.2 to 7.9.21. I followed the procedure according to the Code upgrade doc to create a single Tar file of mini.iso and optional RPMs .tar. install add source harddisk:/ 7.9.21-iso-and-rpms...
I am using XOR (ASR 9K). I need to display all the tags in the ospf routing table. Don't want to go to each specific routes and display it. I need to do some redistribution to BGP but need to know all the tagged routes in the table. Appreciate your h...
Hi friends,I have a home user with ASA 5505 with a Site to Site VPN to my corporate Network. With Site to Site VPN All devices at home user were able to access my corporate network. I would like to restirct it to few devices like PC, Iphone , Ipad ...
Hello,My Cisco VT camera is not working with MAC. I don't have a built in camera in my MAC. I tried using cisco VT camera with MAC and it's not streaming vedio. Is there any driver available for VT camera for MACI goggled but found nothing.... Any b...
I am trying to set up static translation from out side to inside. I couldn't get across. Debug shows incrementing untranslate_hits . Seen few discussion for this topic but no resolution any where. THanks for your help. Attaching config for reference....
Hi Madhuri,I am upgrading from WISM to 5508. I was just configuring HA between two 5508 but after enabling SSO and reboot, The HA is not working. My secondary box went into maintence mode and primary controller stuck in l2 mode. It seems the redund...
Thanks Aaron, It's astonishing that CISCO VT camera is not supported for CUPC in MAC and we need to use third party camera. I think cisco should provide a driver for mac as they do for Windows clients.
