Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm attempting to set up Cisco C9500-40X-A Switches with stackwise-virtual configuration. The installation is new.The port enters the "Not connected" state. following the Switch's virtual link configuration. I initially believed there was a problem w...
I want to replace the faulty Switch in the Stack.removed the faulty from the stackHave configured the Switch priorityconnected the new switch into the stackThe version having mismatch in the newly connected switchhave copied the IOS from the other f...
We have two branch offices and the WAN is connected through IPsec tunnel. Presently those two office has Couple of AP's and it is connected to DC WLC in local- Centralize switching mode. Now we are planning to enable Flex Connect mode to branch offi...
We have configured the CISCO881-SEC-K9 router and sent it to the site. When we try to logging the router it was not accepting the password. I am we sure saved the config on the router. But we tried login with the password it was not working. I also t...
We have installed 3 AP's recently, But the clients are not getting connected to new AP's even though if the client nearest to AP. the clients were connected to the furthest access point instead of the nearest their AP. Out of 4AP's . All the client...
Thanks for the reply, we have QSFP-40G Direct-Attach Cables. we are unable to use because the ports are 10G and it is not supporting to use as to conenct svl. so i have tried to configure the SVL with two 10G RJ45. it is not coming up. The port is wo...
.bin file How to check the boot variable for Switch4 (it is having issue) Goal is to update the IOS and boot the Switch without restarting the entire stacj
S01#sh switchSwitch/Stack Mac Address : 0025.83a0.9200H/W CurrentSwitch# Role Mac Address Priority Version State----------------------------------------------------------*1 Master 0025.83a0.9200 15 0 Ready2 Member 0025.84d1.dc80 14 0 Ready3 Member 00...
We’ve got complains from users disconnection from the wireless network from branch office, and I’ve noticed that there’re quite a fair bit of disassociations from the APs. I have attached the logs Please suggest if any other option available to fix ...
