Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I wants to try to make IPSec Tunnel with one end (spoke) having IPv4 as tunnel source and Hub end is having IPv6 address. Is that possible? as I have tested GRE by having both ends have IPV6 and it is working.Thanks
Hi all,I have an ISR4351 and it has three interfaces. To connect it to switch, the Gig0/0/2 has RJ45 type of connection as well as SFP type as well but for other two interfaces there is only SFP type. problem is that I have switch which has ethernet ...
hello allI am new to ios xr and after some study i started building a small labthe lab is to bring eBgp neighborship between one regular ios and ios xr. they are connected directlycisco ios xr interface ip is 192.168.15.1/24cisco ios interface ip is...
Hi,is there a way that EEM script issues some commands and a way to read all its content and on some specific output results do some action.For example =================================================================TEST#sh ip bgp nei 12.12.12.1 re...
Hi,our router is connected to two isp. ISP 1 and ISP2. ISP 1 is connected through microwave and ISP 2 is connected through Fiber Link(provided by some vendor)..ISP1 gives us P2P Pingable IP.ISP2 gives us P2P Private IP and can be only pingable from o...
yes it is the same hardware as in picture and I am using g2 as RJ45 but wants to use the others two gig0 and gig1 as rj45 and need some module for them
thanks for the reply.the error is %TRANSCEIVER-3-INIT_FAILURE: SIP2: iomd: Detected for transceiver module in Gigabitethernet0/0/0, module disabledAnd the interfaces at my routers are as GigabitEthernet0/0/0 and GigabitEthernet0/0/1 are both SFP type...
The command is not even there. and I guess upgrade might not be possible. so if there is any specific module to solve this issue kindly let me know. thanks
thanks for your response.I am not sure which one to choose as if I buy one at local shop then they will not return. so I appreciate if you can let me know the one that can work for my routerCisco IOS XE Software, Version 03.16.04b.S - Extended Suppor...
