Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I use Cisco CLI Analyzer to analyze the show tech-support from Router, Switch, WLC. The tool can do its job.
I got the issue when I try to analyze show tech-support from Cisco ISE but the tool cannot determine the output I provided....
Hello everyone,
Can you help me to understand the influence of mounting an AP on cable tray directly ?
I am not sure it is a good idea or not.
How about the noise/interference (if yes)?
I think this topic not just for Cisco AP 3702i but for all oth...
Hi everyone,
We have a WLC 5508.
A few days ago, we upgraded software version from 8.0.120.0 to 8.2.151.0. After that, the connection was slow (<1Mbps for b/g/n devices and good with ac devices)
I searched some documents and support topics but I g...
Hi there, This is my configuration on C3850, I use PRTG to monitor netflow.!flow record test-recordmatch ipv4 source addressmatch ipv4 destination addressmatch ipv4 protocolmatch transport source-portmatch transport destination-portmatch ipv4 tosmatc...
Hi Nolan,In my humble opinion, the logging enabled/disabled per firewall rule will choose to collect the log or not for that rule.Example log:2019-03-18 16:33:05 Local0.Info 192.168.0.6 1 1552901590.284212695 <XXXX> flows src=172.17.8.92 dst=125.56.2...
Hi Leo,
Thank you for your comment.
I have the same idea but just "think".
Nowadays, we use CAT6 to connect AP and I think CAT6 can limit the noise/interference alot. In this situation, only the back of AP is covered by metal.
Best regard,
Tuan...
Hi,1/ The controller and other APs are in the same subnet/vlan or not ?If not, just do a test.If yes, hmmm... Never see that so I have no idea about it.2/ Actually, i'm not sure about lwapp command.
Hi, Finally I found this:Manually Configuring Controller Information Using the Access Point CLIIn a new installation, when your access point is unable to reach a DHCP server, you can manually configure needed controller information using the access p...
