About nitesz010

nitesz010 · 04-21-2016

I have a Cisco 2901 ISR running CUCME with the VIC-4FXS/DID for fax machine. Calls are coming in via T1 PRI. What configurations are needed to add a fax machine in one of the FXS port and get it working? I already have all the phones in the system wo...

Applying translation rules and profiles · 02-16-2016

I have four digits extension. What are the translation rules and profiles are needed and how they are applied to the dial-peers so that I will be able to make calls to the PSTN number. In my understanding, I would create two translation rules: One fo...

nitesz010 · 02-12-2016

I am using Cisco 2901 router (CME) with Cisco 7841 SIP Phones. These phone should be able to make conference calls. I think three users can conference with each other by default because I haven't done any configuration and it still works. But the pro...

nitesz010 · 02-09-2016

Hello Everyone, I am using CME-CUE with 7841 SIP phones. I have all the configurations done for the voicemail. When dialing into the voicemail, it starts with the prompt, " Welcome to CIsco Unity Express.......To record a new name press 1, to keep th...

nitesz010 · 02-02-2016

Am I missing something in the following configs? The phones are able to register but cant make calls to each other? Is there anything I need to add to the config to be able to make calls? Current configuration : 8173 bytes!! Last configuration change...

nitesz010 · 04-25-2016

Nadeem, I modified the translation rule 2 to : voice translation-rule 2 rule 2 /.*$....$/ /\1/ But is it not doing the same thing as earlier : voice translation-rule 2 rule 2 /^816...$....$$/ /\1/ (sorry that was not 123, I was changing some ...

nitesz010 · 04-25-2016

Thank you for putting effort into this Nadeem. I have attached the configs.

nitesz010 · 04-24-2016

After adding the configs you recommended I tried making the call and collecting debugs. It still says the call cannot be completed as dialed.... I have attached the debugs if you can find anything. I can't find whats wrong.

nitesz010 · 04-24-2016

I can get the fax number to ring, but after it rings for a while, it says "your call cannot be completed as dialed, please check the number and dial again" Also, there are no slips and errors. #show controllers t1 0/0/0T1 0/0/0 is up. Applique type ...

nitesz010 · 04-14-2016

Is there a way to achieve this in CME?

Member Since	‎09-08-2015 05:02 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	35

User Statistics

User Activity

Fax via FXS in CME

Applying translation rules and profiles

How to configure conference call with sip endpoints?

Cisco 7841 SIP phones dont accept digit while setting up the voicemail

SIP Phones register but cant make calls to each other

Nadeem, I modified the

Thank you for putting effort

After adding the configs you

I can get the fax number to

Re: Caller ID and Call Forwarding