Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone have any expertize or experience in whether to mount these small business Wireless Access Points vertically or horizontially The mounting location is under a wood floor in a long, thin building with all the clients above the WAPs. Thanks ...
This may be a very nieve questionI have a router with two outside interfaces to the internet, a cable modem and a dsl modem. The internal network is a very simply small business network with a server and 5 workstations.Right now i am working with st...
I just installed a HWIC-CABLE-D2 in a 2811 router and connected it to Comcast's nework. The connection works.However the show controllers cable-modem command tells me it is operating in DOCSIS 1.0 mode. How do i get it to operate in DOCSIS 2.0 mode...
I must be missing something. When I select "use this AP as WDS", the Wireless Domain Services Priority field will not take input, and of course, I can not then apply WDS. Using system software version 12.3(2)JA2.I believe I have followed the insr...
Should i select band steering on both the 2.4 and 5 radio or only the 2.4? It appears that if both are selected things slow down on the network on an second SSID on which band selection is not being used
Thanks BrianAll good points. This is a temp rental so i am going for the best i can get as opposed to optimal! I can not get into the ceiling because of the tenant above but there is easy access below. However, your suggestion on finding a closet...
With CME if i did want to configure a PLAR type of config on an incoming SIP trunk where are calls get routed to the same destination what would i need to to?
