About ccieiomlab

ccieiomlab · 05-29-2025

Hello, my request is to understand if it's possible to simulate a few clients with the Always On Catalyst Center Sandbox; and if not, if it makes sense to use the reservable environment just for this.Many thanks,Francesco

ccieiomlab · 06-03-2016

Hello, I am setting up a Cisco CME 10.5 as a conference bridge for SIP Phones. The CME is already serving SCCP phones and the DSPs have been configured to provide hardware resources for conference calls and transcoding. I am now configuring the SIP t...

ccieiomlab · 06-03-2016

Hello, I am setting up a Cisco CME 10.5 as a conference bridge for SIP Phones. The CME is already serving SCCP phones and the DSPs have been configured to provide hardware resources for conference calls and transcoding. I am now configuring the SIP t...

ccieiomlab · 05-19-2016

Hello, I am receiving a logging message from a switch of this type: (SW_3750_1)%CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet5/1 (not half duplex), with SEP111122223333 Port1 (half duplex). (SW_3750_2) While I receognize this as...

ccieiomlab · 05-13-2016

Why is my form page in French even though I selected English ? I might be missing something but one would assume having to select the language once would be enough? Is this normal (acceptable) for a Cisco Portal? Thanks, Francesco

ccieiomlab · 05-30-2025

thank you for confirming this; I wanted to understand if this was possible at least with one of the two environment, especially since it takes 60 minutes to spin up the reservable one

ccieiomlab · 06-07-2016

Problem might be explained from this thread, where it seems that SIP Hardware Conference is not implemented on CME: source: https://supportforums.cisco.com/discussion/11205391/cme-sip-hardware-conference ... Second, I'm not sure if multi-party hardwa...

ccieiomlab · 06-06-2016

Resolved the Forbidden problem by adjusting the dial-peer codecs I now have new error message: "501: Not Implemented" This is more interesting as it showes that the SIP Conference Bridge is not published using the same DN as the SCCP Conference Bri...

ccieiomlab · 06-04-2016

Thanks Jaime, I need to specify an external Conference Bridge to be used by an SPA112. I undertand SPA is an SMB device, however, this case is concerning the CME 10.5 device being used as an external Conference Bridge. On the SPA I have the chance to...

ccieiomlab · 05-19-2016

Hi, I cant copy and paste the output because it is on a separate machine with no internet access. There are several phones connected to the switch. All of these switches have the following flags active: P (Phone), H for Host and M for 2 mac relay fe...

Member Since	‎08-10-2009 07:27 AM
Date Last Visited	‎06-03-2025 01:01 AM
Posts	32

User Statistics

User Activity

Cisco Catalyst Center Alwayson SandBox: Simulating clients

CME Conference Bridge URI

CME Conference Bridge URI

CDP Duplex Mismatch Message and extra info

Why is my form page in French even though I selected English ?

Re: Cisco Catalyst Center Alwayson SandBox: Simulating clients

Problem might be explained

Resolved the Forbidden

Thanks Jaime,

Hi,