Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Anyone know of a way to have a voip dn automatically dial a specified number? That is when you pick up the handset the phone dials the designated number. I've looked around I can't find anything, maybe I'm looking in the wrong place? ...
Hello,Have 2 new c200-m2 servers. Have installed ESXi 5. Created publisher (8.6.2.20000-2) on one server and then had problems when creating the sub on the other server. Sub wouldn't verify connectivity to Pub. Finally got by that but when I chec...
Hello,Have installed 2 Cisco Nexus 4000 i/o modules in IBM H Blade Center. Each 4k has 6 10G uplink ports and 14 Virtual Ethernet ports facing the hypervisor 1 for each blade. (Uplink ports connect to upstream NX5K) Eth1/1 ESXTest1 up trunk full ...
Hello,Our Main Call Handler transfers certain calls back out again. The Call Handler transfer type is set to "Release to the Switch". Only other option is "Supervise Transfer". The receiving party reports that they are only receiving the CLID of t...
Trying to install SU3 to UCCX 8.0.2.10000-41Install fails with this error: There is not enough disk space in the common partition to perform the upgrade. Please use either the Platform Command Line Interface or the Real-Time Monitoring Tool (RTMT) ...
I think Tim Thomas knew this was coming! I've lost all hope of any season, a half season or less would be terrible. I hope they just bag it for this year and get their act together for next year.
Alex, Rob and Bouw,Thanks for the responses! Don't know why I didn't find this info in my searches it's readily available. It was actually quite easy to configure and impliment.Still no Hockey Rob Mark
Given this info supplied by TAC we should be okay:Note that the following deployment options are available under cucm_8.6_vmv7_v1.5.ova:CUCM 1000 user node - C200 (incl BE6K): Cisco Unified Communications Manager (CUCM) configuration t...
The only 1000 node choice for deployment is the c200 BE6000 choice and that just didn't work. TAC finally did get back to me:BE 6K is the Business Edition 6000 configuration, this assumes a single CUCM node cluster, no Subscribers can be added.After...
