Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,At our company we have a redundant ISP connection to two separate ISP's.We are also using VoIP on the network.Currently one ISP connection is used primarily and the second on is just used as a backup.I was wondering if it is possible t...
Hi all,I am currently having a problem with an OSPF broadcast netwerk.I have 3 routers A, B and C.Routers A and B both advertise network 172.16.1.0/24 to router C.Router C now has two routes in it's routing table to the 172.16.1.0/24 network.I would ...
Hi all,I am having a hard time trying to setup a VRRP failover situation where VRRP needs to failover instantly between two routers, whenever a network becomes unreachable.In my case I have two routers, one is the primary gateway, the other one is th...
Hi,Has anyone managed to run CCP in Windows 8 x64?I have installed it, and when I try to run it, it only shows half of the window:I have tried compatibility mode but that doesn't work either.Does anyone have a suggestion?Kind regards
Hi all,I am having a hard time trying to configure DMVPN with the tunnel being sourced via a loopback interface. (Hoping someone could help me out)I have the following network topology:R1 <----------> R3 <---------> R2(Hub) (ISP router) (Spo...
Hi,Let me first say thanks you all for your suggestions.Alain's solution seems to be the best one but I have a little problem when implementing this.I did the following config on both router A and B:routers ospf 1redistribute connected subnets metric...
Also when I issue the command show crypto isakmp sa detail, it shows the following output.Strange thing is when I issue the command a few times, the SA state changes (see below).This is the same on both the hub and the spoke router.
