Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, After upgrade Cisco 5520 WLAN controller from 8.5.151.0 to 8.10.151.0, all Cisco 2802 APs couldn't join controller, however Cisco 2702 AP joins. By looking into AP console, it says 'No valid AP manager found for controller' It seems AP downloade...
Hi, I am not sure how many of you are seeing problem like me, In my 9800-CL HA SSO deployments active role switchover occurs from chassis 1 to chassis 2, show chassis says chassis 1 is removed, active chassis logs ha_port tx hang message, by looking ...
Hi,I am not sure how many of you have noticed active role switchover issues in 9800-CL HA SSO deployment, in my case I have 2 x 9800-CL in same ESXi host, Gig 2 interface is connected to vSwitch1 which is in trunking and promiscuous mode accept, Gig ...
I am not sure how many of you have seen problem like my environment. Almost in all my 9800-CL HA SSO & standalone deployment I have started seeing SWPORT-4-MAC_CONFLICT Issues. ---------Dec 15 09:47:59.848 UTC: %IOSXE-4-PLATFORM: Chassis 1 R0/0: cpp_...
Hi All,
please let me know the procuedure to see Cisco ISE system serial number in GUI, i have searched in all the tabs, not getting, note i dont have access to SSH, so only way is to find it in GUI, Please advise, Thanks.
Hi Sandeep, RTU is activated and has enough license Mgmt and service port is in different networktried capwap ap erase all, no luck, tried factory reset with mode button, no luck
The second picture (Right side) should be 5520 WLC5520 WLC doesn't have Internal DHCP Server feature in it, you can also see this in 5520 product documents.
