Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an issue with ISIS MIB on Cisco 2911 running IOS Version 15.1(4)M1 which supports the MIB as per Cisco SNMP MIB Locator.
This host has many others services which are working fine except ISIS Adjacency e.g. Ping, Device Uptime etc.
SNMP Confi...
Just wondering if switching between SSID's (on different subnets/Vlans) in a foreign/anchor setup can be an example of Inter-WLC-L3/Inter-Subnet mobility/roaming?
To my understanding the mobility is only referred when clients roam on the same SSID in...
I am having similar issue and unable to fix it, can you help ? N9K-C93180YC-FX(config-if)# int eth1/35N9K-C93180YC-FX(config-if)# service-policy type queuing output Output-QoS-1GbpsUnable to perform the action due to incompatibility: Module 1 return...
Hi,
I have a situation where I am looking to connect a router C3925 to FEX, is that something supported, will work, anyone done that?
r-d Cisco 3925 connected to r-agg Cisco 6500
on r-d:
G0/1.200
Vlan 200
Ip address x.x.x.x
TAP PROD
G0/1.60
...
These are some basic config guides for 2 different NX-OS versions available on the same link I shared above.If you are having issues I would recommend work with TAC to fix the problem.Cisco Nexus 9000 Series NX-OS Fundamentals Configuration Guide, Re...
Hi,You can refer to the following for some basic and detailed information around N9K:Compare all N9K products:Compare Models - CiscoNexus 9300 10GBaseT SwitchesCisco Nexus 9000 Series Switches - Install and Upgrade Guides - CiscoCisco Nexus 9000 Seri...
