Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Does anyone have a working example of using FreeRADIUS to authenticate and authorise users for admin access.I have tried using the examples on the FreeRADIUS wiki to no avail although it's almost working. I'm testing the configuration with a 3550...
Hi,CatOS provides an sc0 interface and the 4000/4500 has a management ethernet interface, this is very good for out of band management, the question is what about other switches running native IOS.Assuming that you have a production LAN and you want ...
Hi,I have a 6500 switch that uses a SUP720 in slot 5. If you look at the power, the switch has allocated power to slot 6. Slot 6 is empty, but the switch still marking a section of power capacity as used.Does anyone know how I can stop the switch a...
Hi all,I'm fairly new to NAMs and I have what should be a simple question.I have switches at the centre of my LAN core, the core is Layer 3, so all routed interfaces.These switches are configured with multiple routed interfaces and use a loopback add...
Hi,I'm having issues with Ciscoworks 2.5, but the problems seem to be limited to RME.If I log into Ciscoworks I have access to all areas except RME, if I launch RME I see the 'you may not have permissions' message and I unable to access anything. I'...
you need the firewall feature set. If you want to control what extensions are being downloaded (assuming you mean java applets for example) you need to use CBAC and that's a feature of the firewall feature set. You can also block specific URLs.Assu...
Depending on the type of workstation you are using you should be able to control the routing, just make you standard NIC connection the default gateway.
Hi,I would say that this should not pose a problem, spanning a port should not create a heavy load. Of course if the loading on your switch is very high it's worthwhile monitoring it closely.
Hi,To use IGMP you must have an IGMP querier.Normally an IGMP querier would be a router, but some switches with the newer versions of IOS support an IGMP querier function.Read this:http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_n...
