Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As of right now, I don't have access to the PIX itself but can get access to it later today. In the meantime, I wanted to get everyone's opinions on a very peculiar issue I'm seeing with Internet download speeds.Prior to last week, my company was ut...
I'm not too keen on my terminology, so please excuse me if you get confused...My company recently purchased a C2811 router for a VoIP deployment at a branch office. Currently they are using PRI to connect to their analog (Avaya) phone system. I am ...
I'm a new hire at my place of employment, in which I work at a branch office. Upon arriving, I was told that the network wasn't exactly running up to par with occasional hitches in the network. After doing some investigation, I found the that all t...
I'm a new hire at my place of employment, in which I work at a branch office. Upon arriving, I was told that the network wasn't exactly running up to par with occasional hitches in the network. After doing some investigation, I found the that all t...
I recently just completed installing several Cisco VG204 & VG202 gateways at my office. We use a mix of real fax machines and a Linux server running Hylafax. The Hylafax server is used only for receiving faxes. No users use the Hylafax server to s...
I don't know if I would recommend the 9120 at this time. Backstory: We have dozens of 3702/2702s in production in my environment but with the release of the 9800 Controller, Cisco pushed us in that direction over the AireOS product line. We adopted...
Thanks Anubhav. It looks like the problem was on the switch-side. It looks like the cable modem was plugged in directly into the same port that the router was connected to. The port had the speed & duplex manually set to 100/full. Apparently that...
I'm having the exact same problem as the original poster. I notice that this thread is very old, but perhaps someone could enlighten me to what is going on.The only difference is that the following is what I use for my voice-ports: trunk-group POTS-...
