Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
If I want to manually upload the EAP Auth certificate being used by an ISE server(Administration>System>Certificates>System Certificates) for wireless authentication to a non-Windows based network device, what is the right way of doing it? Is it...
Hi,
Is there a way to view in ISE who's making changes and what those actual changes are? Like an audit changes for ISE itself. I am not referring to TACACS log.
Thanks!
Hi,
We have two WiSMs,one each is installed on 6509-Es acting as distribution switches. These distribution switches will be upgraded and due to switch rack space issue,we're planning to install the WiSMs on a smaller 6504s then trunk them to the new...
Mohamed,
Thank you for the reply. I forgot to mention that this is for medical devices that store medical supplies. I don't know what OS they use but definitely not Windows, MACOSX, nor Linux. We want to try these medical devices to authenticate w...
hi,
I use the command line interface most of the time when configuring ASA and what I usually do is create my own template on Notepad++, which sometimes requires a quite of manual process(it depends how bulk the config change).
If the host ip addre...
Hi,
Try to put the command channel-protocol lacp on the physical ports for Po20 then bounce them. If it still doesn't work, try removing the the command switchport nonegotiate.
HTH
***Please rate and mark the comment correct if you found it usefu...
