HiWe recently found out that we're running a "deferred" ios image on our 4500 access switches. I am wondering what this means and if it's a serious matter. we haven't had problems as far as I know. Should we migrate from a deferred image asap or can ...
I've configured 2 ASAs to work as VPN clustering. Each appliance works fine by itself but when I connect to the Virtual IP using the Anyconnect client I get an error message "Connection attempt has failed due to configuration issue with server" The c...
Could you explain or point me to some links that clearly explain how to configure two 5520s in vpn clustering mode using Anyconnect client? Also, will I need equal licensing on both appliances when they're in clustering mode?
Hi everyone,Under Password Aging Rules I have "Apply Password change rule" enabled but the user does not get a message to change the password. Instead it disables the account after the user logs in once.Any help would be much appreciatedThanks
Please review the following config. Does anyone know what is the best way to monitor that this is doing what is supposed to do? When I apply this config the users complain about slow performance. Help anyone?..class-map match-all SNA match access-...
Hi there. I am wondering about using FP when connecting legacy switches such as 6509s running HSRP to Nexus running FP. What design considerations are important and what't the best way to integrate the two.Can the 2 be run in parallel during transiti...
From a network prespective I wonder if there is anything that is available to auto limit bandwidth utilization when for example serveral Jabber users are streaming a video from a central location at the same time. Even if using VGA resolution 50 use...
Hi MaheshHow can we integrate the VCS witth CUPC client? How do we control the video bandwidth utilization between sites if we don't have multicast enabled on our network?thanks
Thanks for you reply. I have another question.We have as many as 25 people accessing a single access point simultaneously and they are facing slow downs. What's the best way to increase the bandwidth and signal strenght for them? Is adding another ac...
I have a quick question for you. Is it possible to configure multiple group profiles on the Wireless Controller? Currently our SSID defaults to a 2 hour timeout and then users have to log back in. Is it possible to change the timeout to only a group ...
