Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,
After booting the 4500-X switch showing the below message and the switch shutdown automatically .
Anyone knows the solution for this issue ?
Press RETURN to get started!
*Feb 26 23:10:33.922: %C4K_IOSSYS-6-IMAGELEVEL: Supervisor booti...
Hi all,
I have few 1310 LWAPP access points.I don't have any WLC and I want to convert it to autonomous AP.
Please advise me how to convert 1310 AP to autonomous AP if anyone knows.
Thanks
Sudeesh
Dear all,
I am getting the below warning message on my switch, I find that the secondary edge port
is not configured on any switch, In SW019 the interface G1/1 is configured as primary edge but the
output shows below as SEC. Is it becoz the secondary...
Hi All,I have a WLC 5508, its PS1 and PS2 are OFF state, SYS is blinking amber and ALM is continues amber,Its port s are not coming UP and I am not able to access the Controller, All ports are physically down andin console nothing is showing when I c...
Hi Marce,
Thanks for your quick reply, In the link you sent me mentions converting the AP with the WLC.
I don't have any Controller with me.Could you suggest the steps how to convert the 1310 AP to autonomous without
Controller.
Thanks
Sudeesh
Hi Kishore,Thanks for your reply.I added the command "redistribute static " in HO Router,But still I can't ping. Please see the sh ip bgp output after I added the command. I added the network 172.16.1.0 too.Ho#router bgp 64696 no synchronization bgp ...
