Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys
When I'm pinging router gi0/0 interface or hosts behind the router I get high ping drop rate (4-5%) depending on interface utilization.
Router CPU is at 30%, memory is fine, small amount (much smaller than noticeable packet loss) of input err...
Hi We have a strange problem, there is a stack formed of three 2960x switches (same model and IOS), and third member reports strange messages in log regarding inline power:14181681: 14008908: Jun 30 08:39:07.998 UTC: %ILPOWER-3-ILPOWER_INTERNAL_IF_E...
HiI`m trying to make eem applet that will triger "isdn test call int brix/x/x xxxxxxx"command. Applet runns, but this command is not applied and test call is not made! I noticed same behaviour for debug commands while show commands works as expected!...
HiWhen ASA is configured in A/A failover, is it possible to reach 2Gbit/s throughput (1Gbit/s over each ASA) or limitation is set on 1Gbit/s total?thanks
Hi LeoThank you for response. Here you go (it hapens on every port and constantly, so this is most recent one):14190226: 14017340: Jun 30 13:39:58.652 UTC: %ILPOWER-3-ILPOWER_INTERNAL_IF_ERROR: Inline Power internal error, interface Gi3/0/17: failed ...
HiIt was resolved by contacting provider.They had problem on some circuits, but I never received detailed description. For me, it was enough that problem have gone away
Hithank you for you time & suggestion, it was really helpfull!I will stop for now with this test (this is production router ), lowering privilege levels will do the job for me!br,Darijo
