By default ACI multipod IPN L3out OSPF external network are E2. I have requirement to change them to type E1.
is it possible ? how?
I tried to configure route map default export to change E2 to E1 but it did not work.
We have two independent active standby FW-HA in pod 1 and two others FW-HA in pod 2.these FW inspect N-S traffic and E-W traffic. PBR destination in an L3Out was the chosen design option.
We configured one L3out to both FW-HA, but when we configure...
Hi,
we wrote ansible script to create 200 vlan pool in ACI APIC, but execution is too slow. it take more than one hour to finish the job!
With postman it take 2 minutes to create 200 vlan pool.
how can we improve ansible time execution?
after reloading C9300 switch (version 17.6.4), interface te1/1/4 go to down state, and log display:
%SFF8472-3-READ_ERROR: Te1/1/4: Error reading DOM data from transceiver
if I unplug / plug cable in Te1/1/4, interface go back TO UP state. (it is not...
I tried to add catalyst 3560cx as an extended node to SDA fabric but I have this error message:
Device tried to contact the server and failed during certificate_install
how can I resolve this problem?
is it possible to add extended node without using...
Thank you @Torbjørn
adding async 60 and pool 0 to the script reduced time execution to about 4 minutes
the drawback of this method is the result display all tasks in changed state
Hi @willwetherman
after executing
magctl service tls_version --tls-min-version 1.0
PnP process is working and I can see 3560-CX switch in the inventory.
Thank you for your help
request platform software sdwan software install bootflash:image is used to upgrade/downgrade SD-WAN Imageuse this link to upgrade from IOS-XE image to SDWAN-Image:https://www.cisco.com/c/en/us/td/docs/routers/sdwan/configuration/sdwan-xe-gs-book/har...
