This is a new VoIP site at Manila. The issue occured intermittenly from the day one then became hard down in two weeks. The symptom is that local users get busytone upon answering PSTN calls. I have been worked with at least three TAC Engineers and w...
Hi,I am new to switch and router world.One of challenging for me is to understand the meanings of IOS image and find out the right one. Can anyone provide me with documents/explanation? For example, I have a switch with boot loader only - C3560 Boot...
cisco 2821 gateway router with CMEWe are experiencing an issue with voicemail. the inbound calls get busytone after a few rings. Does anyone know how to reboot Unity Express module on gateway router? or any ideas of what I need to do?Thanks in advanc...
We are having an issue with local and mobile dialing in Argintia office. There is newly installed 2921 router with E1 R2 connection to PSTN.the symptom is that when we dial local PSTN or mobile number in digit-by-digit, call goes through. When we use...
yes, i have done the changes then did a test call. the trace - 'debug_2' has been attached for your view. The H323 configuration looks like below after this change -voice service voip allow-connections h323 to h323 allow-connections h323 to sip allow...
Thanks so much for reply.the running-config has been attached. Under voice service, the 'call start fast' is not present. Could you please advise how to disable it?The statement below were added by one of TAC Engineer. He also tried to enable 'Fast s...
Hi Anil,Thanks so much for your reply.Hi Mohammed,To answer your questions -1> ISDN switch type - Per Telco, they uses NI2 as protocol and 5ESS as switch-type. I tried both 'Primary-NI' and 'Primary-5ESS" but got same issue2> isdn incoming-voice se...