Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a couple of hundred DMPs in our network right now. Our internal security team did an audit and is requested that I disable the USB ports on the back of these devices. Does anyone know if this is possible through the GUI or any other way?fir...
VCS x7.2MX200 TC5.1.4We have multiple MX200s in our building which are controlled by a Crestron touchpanel. We have disconnected the cisco touchpanel from these units.The issue that we are experiencing is when I am on a connected call, I cannot ente...
Hello All,I see that the TP Condcutor has VM Option but what i couldn't find it what hardware it is supported on? Is this supported on UCS only or can we install this on a spec based scenerio.I tried to find a Doc Wiki or some documentation but coul...
VCS Control Running 7.0.1VCS Expressway Running 7.0.1Codian 4501 MCU running 4.3(2.18)CUCM running 7.1.5MX200/EX90 running 5.1.3I can initiate multiway calls between my MX200s and EX90 just fine. But if I try to bridge in a audio only call which ...
We have 10 or so MX200/300s and we are finding end users who are accessing the administrator settings on the touch panel and making changes to them. I think some people are just curious and going through the menu option. Is there a way to password ...
Nico,We ended up just using ATAs connecting a cordless Uniden phones much like what you would have in your home. And we only deployed 5 of these units in the office that was requesting it. Range was not an issue because our square footage is smal...
Thomas,Thanks for the suggestion. If I SSH into the MX200 i am able to send DTMF commands and get connected to the bridge. I reconnected the Cisco Touchpanel and dialed into the bride, sent DTMF and got connected. I then checked the event logs on...
The Crestron is connected to the MX200 via the serial port and is sending API commands to control the unit. I will try those commands and post back the results.Regards,Cyril
One more question - I am able to get a couple of our MX200s and a CUCM audio participant into a multiway call. When all the video participants hit the END on the touch panel they will get disconnected but then the Audio participant stays connected ...
