Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there anyway to see what the actual operating data rate/MCS/streams are for a connected Mesh AP?
Seems like something that would be useful to know before doing testing but I cant seem to find that information via 9800 CLI or GUI.
The show mesh bac...
Cisco have recently launched Cloud Delivered FMC, and the question that comes to mind is surely when using FMC from the cloud, every FTD will be remote, and therefore HA management of remote office FTDs will need to be supported!Support for remote br...
HiI have a few questions regarding the licensing of a WSA appliance that is already in service and how to determine whether license count should be increased or decreased.With an existing IronPort S370 WSA how do you determine the actual usage level ...
When configuring Attendant Console (9.x) to overflow to voicemail what is the recommended configuration?Initially I simply configured the voicemail hunt pilot number as the overflow, but that simply results in the call reach the generic Unity Connect...
An 8945 Extension Mobility device profile won't load line button settings when logged in on an 8941, and vice versa when an 8941 device profile is used to log onto a 8945.However, both 8945 and 8941 device profiles successfully load line button setti...
Yes from the CLI using a debug command.
SSH to your RAP
Do a 'show dot11 clients' to find the MAC of your MAP. The MAC address of a RAP/MAP is always plus 11 on the base radio mac, so you can use that to confirm the AP you wish to test.
e.g.
#show d...
Hi BA and SK
Did you get your 9124s works as Mesh Bridge?I have also tried to set this up and had quite a few frustrating problems, but I did get it working in the end.
Definitely had the problem of not being able to select set the mode to Flex+Bridg...
It is FMC in CDO that supports it, but reading the manual and looking at the deployment examples FMC is doing the work.I just fail to to see why this cant be done by on premise FMC alone, its a software limitation that Cisco need to fix, and have nee...
Hi all
Thanks for all of the suggestions for remote HA management, I had come across most of them or variations of them in other forums or posts. My original comment was sharing and expressing some frustration that cloud deployed FMC now supports HA ...
Hi Marius
I hope I am wrong about this as it would make FTD HA deployment much easier. I am aware of remote management via the outside data interface. But are you sure about deploying HA pairs using this management method?
The manual specifically cal...
