Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've just migrated from a 3750 stack to a 3850 stack. They were connected via trunk and all was well. After the migration was complete, we disconnected the trunk and all devices lost connectivity on the new stack. I cleared the arp table, but I...
I just did a trial install of Infrastructure 3.0 at a new company, and it's supposed to have assurance and lifecycle included in the licensing for a certain amount of days. In fact, it mentions it when I start up. With that said, I'm not seeing an...
I recently purchased a few 6502i APs and have them connected to our 5508 WLC. I have all of the bands available, WMM, and all the MCS rates supported. For some reason, I'm not seeing the new APs listed under "Dual-Band Radios". Is there someth...
I currently run LMS, NCS and Prime Infrastructure (testing). We're trying to figure out a way to manage all of our devices and assets that aren't on the network, on top of what LMS is configured for. We don't want to configure the device, just to...
Does Prime Infrastructure have a user tracking/UTLite utility? I'm not seeing it, and it's a vital part of our daily use in LMS. If not, is there any other way to track usernames with 1.2?Thanks in advance.
The issue was the IP addressing. When I created the replacement, I configured it with a different address, which wasn't the gateway address. When I removed the old switch, all devices lost their gateway.
There are no configurations regarding VTP on the switch. There isn't a domain or any others set.If I set these to transparent mode, which one should I do it on first, and will it remove the vlans which are already running on it?I've always set up VTP...
