Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2,000 DID (1,900 actively used now) that I bring into my CUCM system via three PRI circuits. The Telco provides all 10 digits, but I have translation patterns to point them to the four-digit DNs I have defined on my phones (e.g., 789[2-3]XXX >...
I have looked all over and nothing I've found has worked. I have upgraded my CER publisher from 11.5 to 14 (heading to 15). Rather than attempting to upgrade the subscriber, which is on an M4 host, I want to build a new subscriber on my M6 host and c...
I am trying to upgrade from CER 11.5 to 14. When running the pre-check COP file, as well as utils diagnose test from the CLI, I am getting "Error, intra-cluster communication is broken, unable to connect to [IP address of the server on which I'm runn...
I need to upgrade CER from 11.5 to 14 and have access to three ISOs. Does anyone know which I should use for this purpose, or is there a different one I need? 14.0.1.10000-7-recovery.isoBootable_UCSInstall_CER_14.0.1.10000-7.sha512.isoUCSInstall_CER_...
I support 20 school campuses, three additional buildings, and various departments within the administration building. I am using user templates to set the Caller Input for 0 so that the Operator extension points to a receptionist or secretary nearest...
I tried to post my current challenge within the narrow band of my need. At this time, I do not see a need to do a complete renumbering of my dial plan to accommodate 30 DID. That seems a drastic and time consuming effort given that my CUCM infrastruc...
Indeed, the first suggestion is what I was looking for. I was able to filter by Department (in my case, the same as Campus), then use the Bulk Edit to update all those users' Caller Input to route 0 to their local operator. Thank you for your assista...
@Maren Mahoney, I'll start at your last paragraph, as it seems to answer all of the preceding paragraphs. With RTMT pointing at CUC and polling set at 2 seconds, I made the call from 3070 to 2410. Once connection was established, I stopped the pollin...
