03-11-2024 04:47 AM
Hai new Cisco 9115AX AP came with controller mode and I needed to join a controller, no DHCP available on the network, how to enter static IP on AP, i tried to enter like old 1800 AP but the ping and connectivity not working.
converted AP using wireless ewc-ap ap shell
message displayed is Waiting for preferred uplink IP configuration
03-11-2024 05:11 AM
Hi @Kevin100
capwap ap ip address <ip> <mask> and capwap ap ip default-gateway <ip>.
Since you don't have an DHCP to point the AP towards the controller, you would also need this:
capwap ap controller ip address <ip>
03-11-2024 09:38 AM
I tried this still it does not show up and the same message appears waiting for the preferred uplink IP configuration.Not show any ip
APA400.4E3C.5714>show ip interface brief
Interface IP-Address Method Status Protocol Speed Duplex
wired0 unassigned unset down up n/a n/a
apphostintf1 unassigned unset up up n/a n/a
apr0v0 n/a n/a administatively down down n/a n/a
apr1v0 n/a n/a administatively down down n/a n/a
APA400.4E3C.5714>[*01/29/2024 00:11:39.8410] Waiting for preferred uplink IP configuration.
I used wireless ewc-ap ap shell command to rech to shell and used ap-type local
03-11-2024 09:45 AM
First you need to convert controller mode to CAPWAP then configure IP address :
03-11-2024 09:53 AM
I used these commands to convert wireless ewc-ap ap shell ap-type capwap
if I enter ap-type capwap ,ap is already capwap message is getting
03-11-2024 10:48 AM
if the CAPWAP already, then reload the AP and configure the IP as suggested
sitll issue - connect the console - post complete boot logs and the errors you getting to understand more.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide