Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
is there a way to let our users use proxmity without exposing the admin-interface of our telepresence-systems?
Because all our telepresence systems are registered on our CUCMs the share the network as DHCP-clients with normal ip-phones.
To ge...
Hi, we use the chat-integration of social-miner in our UCCX.It works fine, but our agens are unhappy, because there is no popup, when a chat arrives.Is there a way to get a popup, when a call arrives, so the agens are notified about the incoming chat...
Hi,i want to setup a homogenous video conference bridge on my Cisco 2921 running 15.2(4)M1, but I am not able to get this working, because when setting up the dspfarm profile, i have to enter "maximum sessions". The only value I can select here is "0...
Hi,i am currently doing first tests with my ASA running ASA8.4.3 and IPv6 connectivity.It seems to work fine, but I think there is one major feature missing: DHCPv6:There is no way to assign a DNS server to my clients:The ASA does not support DHCPv6,...
Hi,we have two locations, which are connected to the central via an E1 line. On each of the three locations (2 subsidiaries and the central) we have an Cisco 2811 with VWIC2-1MFT on the subs and WIC2-2MFT on the central location.For connecting the PB...
Hi,
i had the same issue:
Jabber-users could see status of S4B-users
S4B-users could not see status of jabber-users
The issue was a setting in the VCS-C, that was nowhere mentioned in any guide:
Go to "Applications" -> "Presence"
Here set everythin...
Hi Wayne,
i do not agree to that. It was and it is always best practice to hide administrative interfaces from normal users. Nobody can hack into a system, that he is unable to access at all. Deployingn Proximity in a typical enterprise environment ...
Hi,to your initial statement: MGCP-calls are not preserved, because L3 is backhauled to the CUCM. So all active calls are dropped a few seconds after outage of CUCM-connection. Only in case of failover t a secondary CUCM the calls are afaik not drop...
I found a solution by myself:When logged on on CUPS and not on CUCM , then Jabber for iPad does not use the settings from the device-configuration-page, but it uses settings done in the UC Service profile.Here I had to configure my ActiveDirectory as...
