Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently installed a BE6K bundle in our office and when the person set it up they did a poor job and used IP's and internal domains instead of anything that will resolve externally. Are there any good guides or suggestions for what and/or where in...
Has anyone ever had any issues with a UHF 2-way radio causing all wireless within a range to drop?i have a customer that has Kenwood 2-way radios in the warehouse TK-8360HUK & TK-3360, and whenever they key up the basestation to start a call, the pc ...
After a power outage the autoattendant and voicemail are down.this is what i see in the service module itself.any ideas?UC_NDi#service-module integrated-Service-Engine 0/0 sessionTrying 10.1.1.1, 2002 ... OpenCisco Configuration Assistant. Version: 3...
I have 2 phones that are both doing the same thing.after resetting them the are stuck in a continuous reboot and sitting at the cisco screen with a target symbol at the bottom left.Any ideas what i should try?the loads are in my UC520 system, and we ...
I have 2 phones that are both doing the same thing.after resetting them the are stuck in a continuous reboot and sitting at the cisco screen with a target symbol at the bottom left.Any ideas what i should try?the loads are in my UC520 system, and we ...
No i just built this asa, the only thing it does is NAT and has a site to site tunnel.Which i can get to the IP camera fine from its inside address over the tunnel, but i have no luck getting it to work in 8.4.
