Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We currently have a single Expressway C & E with the E deployed behind an ASA as per 3-Port FW DMZ with Single VCS Expressway LAN Interface (http://www.cisco.com/c/en/us/support/docs/unified-communications/expressway/118992-configure-nat-00.html#...
Hi,
We have successfully deployed Jabber MRA for a customer. The internal dialplan is a 4 digit plan. AD has the users 4 digit DN in the telephonenumber field which works very well for on premise requirements. Unfortunately when a call is made from ...
Hi all,I have a financial customer who has requested SIP TLS for all gateway signalling. For failover I have a couple of gateways with a single PRI in each. Is there a neat way to take the SIP trunk out of service if the PRI goes down in the primary ...
Hi,Been working with TAC on an issue last week and the case is now closed; I now need to disable all micro traces that were enabled on the cluster.Other than going through all services on all servers and deselecting all traces is there a mroe suitabl...
Hi,We have a pair of CUBEs, one each in two Data Centres behind ASAs. Each ASA has a static NAT on a public IP to the internal CUBE in that location. The ITSP automatically fails over inbound calls to the second trunk if the primary goes down. Inboun...
I've been selling, installing and supporting cisco for over 20 years. It is now apparent they treat their customers and partners with such disdain that I actively encourage my customer base to use *anything but cisco*. Really - they were a good compa...
Thanks for the confirmation Jonathan. I read the guide and there was no *specific* mention of the 3 port dmz configuration so I didn't want to make any assumptions. Similarly the guide just mentions an expressway cluster but can you confirm if a clus...
Hi JuanDid you ever get a resolution to this ? I have the same problem on CUCM9.5 (so I don't think the device pack is an issue). I have 7 x 8945's stuck on 9.1(2). I have tried upgrading to 9.1(2)SR1 but the phone just goes back to 9.1(2). Similarly...
