Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a voice gateway which is registered as MGCP to CUCM. This voice gateway has a hotline analog phone (FXS) and PSTN line (FXO) connected to it. Can someone help me on how to configure the hotline phone that when the handset is lifted, it will...
Can someone help to verify if the TelePresence ISDN Link (CTS-ISDNLINK-K9) supports SNMP?I've been reading the Admin Guide and API Reference Guide manual but there were no SNMP configuration settings.
Hi,I have a Cisco AIR-LAP1262N-E-9 but I cannot access via console and GUI. Also, I noticed that after getting IP address from DHCP server, its IP address will be released after 2minutes. Then after a while, the access point will get another new IP a...
Hi,Can someone explain what is the purpose or meaning of "OSPF for Routed Access" in IP Base license for 4500 switch? I'll be installing 4500 switch for my distribution, and 6500 switch for my core. These two switches will use OSPF as their routing p...
Hi,I recently upgraded the IOS of the router of our customer to have a CME ver. 9.5. After the upgrade, the cme-srst license type became "EvalRightToUse", and the license state became "Not in Use, EULA not accepted". So I configured the router to acc...
Hi Roger,Thanks for the inputs. However, the example on the link you shared didn't work for me. The sample configuration is for Hotline on extension number to extension number. My situation is, the Hotline analog phone will automatically dial an outs...
Hi Wayne, Thanks for your reply. I got some clarifications though: Basically, we want to monitor the ISDN Link Device, at least its network connectivity. For instance, when the device goes down, the NMS server will show an alarm/alert. Is this possi...
Hi Manas,Thanks for your comments.I have a WLC 5508 controller. I just want to have a basic setup for my upcoming project implementation. On my test bed, I have WLC, 2 sets of AP, and PoE L3 switch. The L3 switch serves as a DHCP server to APs. I ma...
