Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I started to discover the new CAT3850 switch and it seems to be that I fail with a basic setup: I am not able to terminate the CAPWAP tunnel from an Access Point (3502E) on the CAT3850.The AP is directly connected to the switch. I am using VLAN10 ...
The RME (Config Archive Management)of our LMS3.0 installation reports a lot of out-of-sync devices.Most of same are based on <no scheduler allocated>, <terminal length> etc. which is not really important for us to see. Therefore, we have excluded the...
When PIX forwards an ARP Request in transparent mode, it inserts its own (!) mac address as source in the ethernet header. So it is not really transparent. E.G.:Original ARP Request:ETH Source: PCETH Destination: RouterARP Sender HW: PC IP: PCARP Rec...
I have a brand new PIX-515E, which was delivered with R7.X. Nevertheless, I have to downgrade the pix to R6.3.This seems to be a problem, because with the downgrade command I have to enter a 4-tuple activation key. But I do not have one, because I´am...
Does anybody know (or have a link) why there are still 2 release lines for Concentrator 3000 Series: 4.1 and 4.7 ... and what are the major differences?Thanks in advanceEdgar
It should be an expected behavior (Administration Guide 2.3, Chapter : Set Up Cisco ISE in a Distributed Environment):
In a high availability deployment, when the primary pxGrid node goes down, it might take around 3 to 5 minutes to switchover to the...
... ok, we finished our tests. From our perspective this a bug. ICMP ND uses Solicited MC addresses (means an IPv6 MC address which belongs to the IPv6 unicast address of the node). Of course Solicited MC addresses will never be registered using MLD....
There are strict rules to map L3 IPv6 Addresses and L3 IPv4 addresses to L2 Mac Addresses. At the end those Mac Addresses are Multicast addresses independent of their roots (IPv6 or IPv4). Of course you are able to keep them separate from each other ...
Michael,it works like designed: multiple match is a first match out based on the AuthZ Parameters. E.g.:- Rule 1: DACL1, VLAN10- Rule 2: DACL 2, Timeout X... the AuthZ Result is DACL1, VLAN10 and Timeout XIt is not a Merger of DACL1 and DACL2.From my...
The MSI is the clue between Rich Media Endpoints / Rich Media Applications and the Services provided by the network. It is part of the Medianet Framework. It seems to be that the Jabber Client is using MSI e. g. for Service Discovery (MSI provides d...
